Linear Symmetric Dimension Type

Announcement
August 29, 2018

Posted on August 29, 2018 by Synergis Helpdesk Technician Mark Lancaster The other day I received a call from a customer looking to dimension a detail view per the image below. Within a couple of days of providing the solution to the customer, this same question appeared on the Autodesk Inventor Forum. Perhaps it’s time […]

Autodesk Inventor: Dimensioning to An Applied Intersection

Announcement
December 5, 2013

Posted on December 5, 2013 by Mark Lancaster, Synergis Product Support Specialist: A while back I had a request to create a dimension to an applied intersection on an Inventor drawing.  Normally this is not something that is done frequently, so I wanted to share the steps to remind everyone how this is accomplished. I […]

Synergis Technologies. ©2020 - All Rights Reserved.

img

Synergis Technologies. ©2020 - All Rights Reserved.