Tags3d design 3d modeling akn_include autocad autocad electrical AutoCAD tips Autodesk autodesk 2015 autodesk event Autodesk Inventor autodesk revit autodesk subscription autodesk training autodesk vault BIM BIM 360 BIM Building Information Modeling building design building information modeling civil 3d civil design data management design digital prototyping engineering design fusion 360 how to infrastructure design inventor inventor tips manufacturing manufacturing design new features PLM 360 Revit scanning simulation software Subscription Synergis University technology tips training Vault what's new
Most Popular Posts
Ready to Take the Next Step?
March 4, 2015
Posted on March 4th by Dave Breiner, Synergis Manufacturing Solutions Engineer
What can you expect from a sheet metal bend corner? How will it look and how can you adjust them? Today I will give you some examples of bend corners and how they appear in the flat pattern and the folded model.
I will begin by addressing how to change the GAP between 2 Flanges. The Material I am using is Stainless Steel 11GA which generally measures .125 inches thick. The default setting in our Rule set the Gap at the thickness of the material.
If you would like to close this Gap to aid in welding, you only need to enter a distance under the Seam Gap spacing. In this case, I will enter .01 inches.
There are several options under the corner tab for 2 and 3 bend intersections. I will review a few from each and show the results.
2 Bend Transition
Round – A corner relief defined by a circular cutout in the flat at left. The cutout has a center placed on the intersection of the bend lines. Below are two views of the folded corner.
Square – A relief shape with a square cutout and centered on the bend line intersection of the two bend lines.
Tear – A relief shape defined in flat by extending the flange edges to their intersection. Named due to material failure caused by tearing across the bend zone in the folded model.
Corner Relief Size
For a 2 bend intersection such as a Square or Round. When any two flanges or Contour Flanges meet at a 2 Bend corner, a parameter called CornerReliefSize is applied. This parameter sets the space between the Flanges. CornerReliefSize is defined by the Sheet Metal Rule, of which the default setting is 4 X the Thickness at below first. 2 X the Thickness is shown after.
3 Bend Intersection
Use this option to define the Default corner relief to display in the flat pattern when 3 bends intersect.
Note: The folded model does not display the selected relief option.
No Replacement As indicated, no replacement of the “as modeled” geometry is made in the flat pattern.
Intersection A corner relief shape defined in the flat by extending and intersecting the flange edges.
Full Round A corner relief shape defined in the flat by extending the flange edges to their intersection and then placing a fillet tangent to the bend zone tangency lines. Radius will likely be larger than what would be produced using the Round with Radius option.
Round with Radius A corner relief shape defined in the flat by extending the flange edges to their intersection, and then placing a tangent fillet of the size specified. Radius will likely be smaller than what would be produced by the Full Round option. When using the Round with Radius relief shape a size field is available. By default is set to the thickness.
You may need a little trial and error to achieve the corner bend you are looking for but there are a lot of choices to aid in your decision making. I hope you found this article informative and helpful.
Till next time!