Live Webcast - October 13, 2022 - 11:00 AM - 12:00 PM
Set up materials, designs, and cutting areas calculated for optimized cutting.
Thursday, October 13 @11:00 AM EST
Would you like to improve efficiency in the way you cut similar shapes on a cutting table?
That optimization is called Nesting, and there is an extension within Fusion 360 that can help us deliver an outcome. Some of you might already know about Nesting in Autodesk Inventor, but did you know Fusion 360 has it too? This webinar will show how to set up materials, designs and cutting area and calculate them for optimized cutting.
This webinar will show:
- How to access the Fusion 360 Nesting Extension
- How to setup materials and cutting areas
- How to optimize designs within the Nesting Extension
- How to simulate the cutting of the design